Back to journal

Avenyora reflection

Why Stars Twinkle More Than Planets: A Sky Test

A bright star can flash colors near the horizon while a planet looks steadier. Learn what causes the difference and try a comparison at the same height.

Cosmic illustration for Why Stars Twinkle More Than Planets: A Sky Test

To see why stars twinkle more than planets, consider the apparent size of each object. Earth's moving air distorts the light from both, and a distant star is effectively a point for this observation. A planet such as Jupiter has a disk you can resolve through a telescope, even when your eyes see it as a dot. The light from different parts of that disk can fluctuate differently, so the combined brightness usually looks steadier. The comparison works best when both objects are at a similar height above the horizon.

What changes when a star flickers

Look at a bright star for several seconds. It can briefly brighten and dim, and sometimes flash different colors. Those short changes in apparent brightness are called scintillation. Air with slightly different temperatures and densities bends the incoming light by different amounts as it moves across your line of sight. For an observer on the ground, this can change how much light reaches the eye from one moment to the next. NASA Goddard's astronomy explanation also discusses how turbulence makes the apparent position of a star shift a little.

Astronomers use the term seeing for the disturbance of an image caused by atmospheric turbulence. The two effects are related, but steady brightness tells you little about whether fine detail will hold steady through a telescope. The European Southern Observatory's adaptive optics guide shows how observatories measure and correct atmospheric distortion to recover more detail. A planet can look steady to your eyes while the fine markings on its disk waver in the telescope.

Why a planet's tiny disk matters

To unaided eyes, a bright planet and a bright star can both look like points. A telescope can resolve the disk of a planet such as Jupiter, whereas an ordinary star remains effectively pointlike in this comparison. When the air makes light from one direction momentarily brighter, light arriving from other parts of the planet's disk can fluctuate by a different amount. These changes tend to average out when your eye takes in the whole disk. NASA's Radio JOVE tutorial describes this averaging and the stronger twinkling commonly seen near the horizon.

How well that averaging works depends on the planet's apparent size and the air you are looking through. A planet can flicker, especially low in a turbulent sky. A high star can look almost steady for a while. Brightness and steadiness give you something to investigate, with the chart and the object's position providing the better evidence for its identity.

Why the same star can look different near the horizon

When you look low, the light travels along a longer slanting path through the atmosphere than it does when you look high. The path crosses more air, and the effects of turbulence often become easier to see. NASA Ames uses Sirius as an example of a bright star that can flash strongly near the horizon. Its quickly changing colors are part of what you see through the atmosphere. A sustained tint and a sequence of rapid flashes are different observations. A flash of red during a few seconds of watching does not imply that the star itself has suddenly changed color.

A roofline can also make one view less comparable with another. Air rising from a warm surface may disturb the image along that particular line of sight. If your low target sits just above a roof, note that in your observations. The guide to measuring the Moon illusion uses a separate horizon effect to show how important it is to distinguish what you notice from what your comparison actually measures.

Compare two confirmed objects at a similar height

Pick a night when a bright planet and a bright star will both be visible from where you stand. Check their identities first on a sky chart set to your location and local time. For a first comparison, look for two targets fairly close in height above the horizon, ideally in the same general part of the sky. Observing a low star against a planet almost overhead makes it difficult to tell how much of the difference comes from their altitude.

Watch each object for roughly ten to fifteen seconds and alternate several times. Note whether you see quick brightness changes, color flashes, or something steadier. Avoid comparing two points through different patches of moving cloud. Thin cloud can change how bright an object looks over a few seconds even when you can still see it. If you need more darkness to identify the comparison star, the twilight guide can help you decide how late to go out.

For a second observation, follow the same identified star when it is lower or higher in the sky, if it reaches those heights while visible. Record the time, approximate altitude, viewing direction and any obvious change in conditions. The setup will rarely be identical. Repeating the comparison on another clear night can help you check whether the stronger flicker occurred reliably when the object was low or just during one unsteady stretch of sky. A simple note such as “bright and nearly steady for three turns” is enough to compare with a later observation. It preserves what you actually saw before you try to account for the difference.

Use the flicker as a clue when identifying a light

If you spot a colorful point before opening a chart, first note when and where you saw it, including how high it was and which direction you faced. See whether it holds its place relative to nearby stars over several minutes. The whole pattern drifts as Earth rotates, so compare the light against the pattern rather than a roof or tree. A light that moves across the pattern can be something else, such as an aircraft. It may take time to notice the movement when the light is headed roughly toward you.

A bright point that matches the chart position of a planet can still flicker. If you want a stronger check on a planetary identification, compare its place against background stars over more than one night when the motion is detectable. The two-night guide to identifying Uranus gives a worked example for a much fainter target. The same principle applies to an easy naked-eye candidate. Use position first and let the appearance tell you something about observing conditions.

Frequently Asked Questions

Can Jupiter or Venus ever look as though it is twinkling?

Yes. The effect is often weaker than for a nearby comparison star, but strong turbulence and a low altitude can make a planet look unsteady. Try a new comparison when the planet is higher and check its position on a chart.

Why does Sirius sometimes flash red and blue?

Turbulent air can make the brightness of the colors reaching your eye change quickly, particularly when Sirius is low. Watching the star at a higher altitude gives you a way to test whether its apparent flashing is less obvious through a shorter atmospheric path.

Is a steady light proof that I have found a planet?

A star can look steady under favorable conditions. Identify the object from the time, direction and its position relative to nearby stars. Its steadiness is an observation you can note alongside that identification.

Do I need a telescope to compare twinkling?

Unaided eyes are enough to compare the apparent brightness of two readily visible objects. A telescope can show a bright planet's disk and reveal image blur, which is a separate observation from how steadily the whole object seems to shine.

Privacy on this device

Clear tool inputs, results and pending saves from this browser, then reload this page. Unsaved numerology, basic compatibility and guest tarot results disappear on reload. Saved account data, downloads and other devices are separate. Your sign-in and analytics choice stay as they are.